Yes, I've tried with SendDTMF, and it works, but if I do that, then * looses control of the call. That is, the call is transfered to the new extensions on the PBX but since * is not in the calll flow anymore, it doesn't know if on the other end they have ansered or not.
----- Original Message ----- From: "Steven Critchfield" <[EMAIL PROTECTED]> To: <[EMAIL PROTECTED]> Sent: Tuesday, May 18, 2004 5:56 PM Subject: Re: [Asterisk-Users] problems with analog interface to PBX > On Tue, 2004-05-18 at 15:45, Dan Fernandez wrote: > > Steve, > > > > Thanks for your respnose. The flash does seem to work. If I plug a phone on > > the x100p I can hear with the x100p flashes. I then get a dialtone. The > > problem is that when i try to dial again from that card, i get "cannot > > create zap channel". It seems that because the line is now off hook, the > > dial cannot proceed. > > Without having read the thread, flash returns you to the channel. From > that point use senddtmf to "dial" the numbers you want on the channel > you already have. > > > ----- Original Message ----- > > From: "Steve Creel" <[EMAIL PROTECTED]> > > To: <[EMAIL PROTECTED]> > > Sent: Thursday, May 13, 2004 11:04 AM > > Subject: Re: [Asterisk-Users] problems with analog interface to PBX > > > > > > > On Wed, 12 May 2004, Dan Fernandez wrote: > > > > > > >Folks, > > > > > > > >For the last few days I've been trying to experiment with a Panasonic PBX > > > >and an X100P but have run into quite a few problems which I am not sure > > > >if they can be solved with this type of card (how about TDM01B?) > > > > > > > >1) I wanted to use *'s IVR capabilities, so I routed the calls to the > > > > extension where the x100p was connected to. > > > > > > > >Asterisk should answer the call, playback a message, dial another PBX > > > >extension and if no one answers dial another extension (via IAX). > > > > > > > >The first problem I ran into was that the Flash application doesn't > > > >really work. To get around this I added another x100p to dial the new > > > >extension. The problem I ran here was that even though I specified in the > > > >Dial app to just dial for 30 seconds, it rang forever as if * cannot > > > >recongnize that no one had picked up. Asterisk does seem to detect > > > >hangups and busy tones (I have busydetect=yes and busycount=10) > > > > > > For about 6 months, we were using the same logical setup (a channelbank of > > > FXO cards for a Merlin Legend switch, with asterisk doing incoming IVR / > > > autoattendant, then transferring the calls out to the Legend, and > > > handling voicemail). The first problem I encountered that I hadn't > > > expected had to do with asterisk transferring the call back to the Legend. > > > I did a Flash(), a SendDTMF(), and another Flash() - the Legend saw this > > > as an attended transfer, and it caused some oddities. Turns out I needed > > > to Flash(), SendDTMF(), Hangup(). Along the way, I found the Flash times > > > that the legend was expecting to see, and adjusted them in the source > > > code, so as to eliminate occasional flash detection problems. > > > > > > I'd take time to plug an analog set into the extension you have the X100P > > > on, and make sure you can flash/transfer calls like you're expecting > > > asterisk to. There's no reason (that I know of) that your flash can't > > > give you exactly the behavior you're looking for. > > > > > > Good luck to you, > > > > > > Steve > > > _______________________________________________ > > > Asterisk-Users mailing list > > > [EMAIL PROTECTED] > > > http://lists.digium.com/mailman/listinfo/asterisk-users > > > To UNSUBSCRIBE or update options visit: > > > http://lists.digium.com/mailman/listinfo/asterisk-users > > > > > _______________________________________________ > > Asterisk-Users mailing list > > [EMAIL PROTECTED] > > http://lists.digium.com/mailman/listinfo/asterisk-users > > To UNSUBSCRIBE or update options visit: > > http://lists.digium.com/mailman/listinfo/asterisk-users > -- > Steven Critchfield <[EMAIL PROTECTED]> > > _______________________________________________ > Asterisk-Users mailing list > [EMAIL PROTECTED] > http://lists.digium.com/mailman/listinfo/asterisk-users > To UNSUBSCRIBE or update options visit: > http://lists.digium.com/mailman/listinfo/asterisk-users > _______________________________________________ Asterisk-Users mailing list [EMAIL PROTECTED] http://lists.digium.com/mailman/listinfo/asterisk-users To UNSUBSCRIBE or update options visit: http://lists.digium.com/mailman/listinfo/asterisk-users
