I have a Linux 2.6.6 box with Hyperthreading with a Digium 4 port T1 board [TE-405P ?] Intel P4 3.2 w/ HT and the board is an Intel 875 w/ HT support.
So far no issues. I did have a hard-lock six hours after first booting the box, but so far it has been up since then [uptime 5 days 16:11], and actually has higher load than when it locked [had no load then]. Call quality is perfect. I will reply again to this thread if any problems do crop up. > Message: 10 > Date: Tue, 08 Jun 2004 08:44:19 +0800 > From: Steve Underwood <[EMAIL PROTECTED]> > To: [EMAIL PROTECTED] > Subject: Re: [Asterisk-Users] Hyperthreading? > Reply-To: [EMAIL PROTECTED] > > Chris Bond wrote: > > >Are they any issues still with hyperthreading processors, I've read and been > >told by a few people to make sure its disabled in bios if I want to use * on > >a hyperthreading machine. > > > > > A lot of people report no problems with HT turned on, but you have to > look at these reports carefully. A lot of people have no zaptel hardware > in their system. That seems OK with HT on. Some people with zaptel > hardware use it in very simple ways. That also seems OK. However, if you > try things like setting loopback on a TE410P card with HT turned on, the > machine locks solid. So, there are HT issues, but not everyone hits them. > > Regards, > Steve > > _______________________________________________ Asterisk-Users mailing list [EMAIL PROTECTED] http://lists.digium.com/mailman/listinfo/asterisk-users To UNSUBSCRIBE or update options visit: http://lists.digium.com/mailman/listinfo/asterisk-users
