Hello, I'm trying to setup asterisk with T100P and Adit600 (3FXS & 1FXO), can you please help with the configuration needed?
Thanks Shlomi -----Original Message----- From: [EMAIL PROTECTED] [mailto:[EMAIL PROTECTED] On Behalf Of Andrew Kohlsmith Sent: Monday, June 21, 2004 9:29 PM To: [EMAIL PROTECTED] Subject: Re: [Asterisk-Users] integrating with existing PBX On Monday 21 June 2004 15:19, Florin Andrei wrote: > Any high-level guidelines on how to integrate Asterisk with a PBX that's > already in use? Probably that particular PBX is not supported directly, > but are there ways to somehow hook-up to it and route calls from IP to > PBX or back? Depending on the number of trunk lines you need and whether you can do digital trunk interfacing: A T1 card (T100P or TE405P) and if you can't do ct1/PRI into your phone system: an FXS channel bank. I recommend the Adit600 personally but YMMV. I recommend the channel bank over using the TDM400P with FXS ports as I have found through my use of the TDM400P at home (3 ports) that the channel banks are by and large more stable and have better voice quality, although it's a fine line. I'm doing the T100P+Adit600 route on a few Norstart MICS systems right now, and will be converting one of htem to a PRI interface and ditching the channel bank to save on wiring and also to experiment with some DID/CLID experiments with the Norstar system. Regards, Andrew _______________________________________________ Asterisk-Users mailing list [EMAIL PROTECTED] http://lists.digium.com/mailman/listinfo/asterisk-users To UNSUBSCRIBE or update options visit: http://lists.digium.com/mailman/listinfo/asterisk-users _______________________________________________ Asterisk-Users mailing list [EMAIL PROTECTED] http://lists.digium.com/mailman/listinfo/asterisk-users To UNSUBSCRIBE or update options visit: http://lists.digium.com/mailman/listinfo/asterisk-users
