Spectro, I have a T100P connected to my Merlin Magix and it works like a champ. I am using an older T1 card (one pulled from a Merlin Legend) without any problems. The card is a "100D 1 T1 Trunk" blade.
I have my system configured as a PRI (23B+D). The T100P is configured to signal with pri_net and to provide timing. I used the 5ESS protocol, but I suppose any of the PRI variants supported by both devices would work. I do not have (or need) any CSU/DSU equipment in between the two devices. I simply built a crossover T1 cable (warning - not the same as an Ethernet cross-over cable) and connected the two devices. The card and the switch synched up and worked immediately. The hardest part was programming the ARS table to properly make use of the connection. As for the insertion of the new card -- I had to do a "board renumber" and it did mess with the dial plan on the switch a bit. Stations did not change, but the trunk numbering did. (This may be specific to my installation -- Magix/Legend are a field unto themselves.) Good luck with the install. My number is below if you have additional questions. Thanks, Steve Steven Sokol Owner/Manager Sokol & Associates, LLC Phone: 816.822.1807 IaxTel: 700.613.9004 Web: http://www.sokol-associates.com ASK ME ABOUT AstriCon 2004! http://www.astricon.net/ > -----Original Message----- > From: [EMAIL PROTECTED] [mailto:asterisk-users- > [EMAIL PROTECTED] On Behalf Of spectro > Sent: Sunday, August 22, 2004 11:25 AM > To: [EMAIL PROTECTED] > Subject: [Asterisk-Users] asterisk T100P to Merlin Legend > > Management just approved purchase of a Digium T100P and a T1 card for > our Merlin Legend Switch. I will appreciate comments from anyone > performing this installation before: > > - Which T1 card did you use in the Merlin Legend? > - Did you require any special interface? (CSU/DSU, etc) > - Any items to watch during installation. > > Also we will need to remove one of our old analog Trunk cards to > accomodate the new T1 interface in the switch. This switch already has > two T1 cards in it. I don't know much about restriction in the Merlin > Legend Switch, but our phone tech told me some horror stories about > taking a card out of the switch. I know this is OT and we will > probably have our switch part supplier to take care of that but I will > appreciate any comments. > > Thanks in advance > _______________________________________________ > Asterisk-Users mailing list > [EMAIL PROTECTED] > http://lists.digium.com/mailman/listinfo/asterisk-users > To UNSUBSCRIBE or update options visit: > http://lists.digium.com/mailman/listinfo/asterisk-users _______________________________________________ Asterisk-Users mailing list [EMAIL PROTECTED] http://lists.digium.com/mailman/listinfo/asterisk-users To UNSUBSCRIBE or update options visit: http://lists.digium.com/mailman/listinfo/asterisk-users
