I have the same hardware (x2)
/etc/zaptel.conf file
fxsks=1-2
loadzone=au
defaultzone=au
/etc/asterisk/zapata.conf file
[channels]
language=en
context=inbound
group=1
musiconhold=default
; need these much shorter than defaults
flash=90
signalling=fxs_ks
threewaycalling=yes
transfer=yes
echocancel=yes
echocancelwhenbridged=yes
echotraining=yes
;busydetect=no
busydetect=yes
;busycount=6
callprogress=no
channel => 1
channel => 2
from /etc/asterisk/extensions.conf
exten => _X.,1,Dial(Zap/g1/${EXTEN})
I had some noise issues at first, and then I used a decent shielded cable
between the cards and the wall socket and that cleared it up...
YMMV.
Cheers,
Peter
-----Original Message-----
From: [EMAIL PROTECTED]
[mailto:[EMAIL PROTECTED] Behalf Of Imran Akbar
Sent: Friday, 3 September 2004 4:08 PM
To: Asterisk Users Mailing List - Non-Commercial Discussion
Subject: [Asterisk-Users] digitnetworks card issues?
Hi,
I've purchased two x100p clones, and when I try accessing a line
from asterisk with something like this:
exten => _1NXXNXXXXXX,1,Dial(Zap/2/{$EXTEN})
(is that only supposed to put you on channel 2 or actually dial the #
for you?)
but I first hear noise, then a dial tone, but as soon as I start dialing
numbers I get feedback and noise, and the call doesn't go through.
Any suggestions?
_______________________________________________
Asterisk-Users mailing list
[EMAIL PROTECTED]
http://lists.digium.com/mailman/listinfo/asterisk-users
To UNSUBSCRIBE or update options visit:
http://lists.digium.com/mailman/listinfo/asterisk-users
