What version of libtiff you have? I had similar problems until I switched down to 3.5.7, and now all faxes work perfectly. Make sure to fully remove older/newer versions before installing a new libtiff.
On Mon, 2004-09-20 at 10:02, Maurizio Marini wrote: > debian sid with 2.6.8.1 kernel > at last i was able to get spandsp compiled (see my last post) > now i try to receive a fax but ...core dump!! :( > here the output at console (nothing under /var/log/asterisk): > > Changed from phase 0 to 1 > Slow carrier up > Slow carrier down > Start receiving document > Changed from phase 1 to 4 > Sending ident > >>> CSI: 40 20 20 20 20 20 20 20 20 20 20 20 20 20 20 20 20 20 20 20 20 > DIS: > Preferred octets: 256 > Can receive fax > Supported data signalling rates: V.27ter and V.29 > R8x7.7lines/mm and/or 200x200pels/25.4mm OK > 2D coding OK > Scan line length: 215mm > Recording length: A4 (297mm) > Minimum scan line time: 0ms > Minimum scan line time for higher resolutions: T15.4 = T7.7 > Get at 9600 > Changed from phase 3 to 5 > Fast carrier up > Coarse carrier frequency 1712.90 (88) > Fast carrier down > Fast carrier up > Coarse carrier frequency 1700.09 (66) > Training error 7.764798 > Training succeeded (constellation mismatch 6.026207) > Fast carrier trained > Fast carrier down > Changed from phase 5 to 4 > Start rx document - compression 2 > Start rx page > >>> CFR: 84 > HDLC underflow in state 5 > Post trainability > Changed from phase 4 to 5 > Fast carrier up > Coarse carrier frequency 1699.83 (66) > Training error 6.394423 > Training succeeded (constellation mismatch 10.554763) > Fast carrier trained > Ouch ... error while writing audio data: : Broken pipe > Segmentation fault (core dumped) > Warning, flexibel rate not > heavily tested! > > some guru can help? _______________________________________________ Asterisk-Users mailing list [EMAIL PROTECTED] http://lists.digium.com/mailman/listinfo/asterisk-users To UNSUBSCRIBE or update options visit: http://lists.digium.com/mailman/listinfo/asterisk-users
