The problem with the (not-so) Smart Jack is that they fail regularly. I have had so many problems caused by the Smart Jacks, that I don't use them anymore - just plug into the can. And, no green Digium light until you load the software.
Jon ----- Original Message ----- From: "Steven Critchfield" <[EMAIL PROTECTED]> To: "Asterisk Users Mailing List - Non-Commercial Discussion" <[EMAIL PROTECTED]> Sent: Monday, October 11, 2004 2:02 PM Subject: Re: [Asterisk-Users] T100P to Verizon Smart Jack Question > On Mon, 2004-10-11 at 11:45 -0400, Cirelle Enterprises wrote: > > Has anybody had any experience connecting the t100p to > > a verizon smart jack. > > > > I've been told the t100p uses an RJ48 but not the revision > > (i.e. C, S, X ) > > > > I've created wires (RJ48C x-over) but no green light on the t100p > > > i've created wire (RJ48S) no green light > > (only because the HyperEdge Smart Jack says this is default > > but can't confirm this to be true in my case). > > > Standard RJ45 ether cable gets ligts on the card and smart jack > > but no signal > > Then you should have noticed then that no cross over cable is necessary > to a smart jack. Only time to use a cross over cable is when connecting > 2 end devices together. > > > zttool indicates OK for both the t100p and the tdm04b cards (no alarms) > > I can ping the t100p but no further with the standard ether cable > > Are you doing data or voice on the T100P? > -- > Steven Critchfield <[EMAIL PROTECTED]> > > _______________________________________________ > Asterisk-Users mailing list > [EMAIL PROTECTED] > http://lists.digium.com/mailman/listinfo/asterisk-users > To UNSUBSCRIBE or update options visit: > http://lists.digium.com/mailman/listinfo/asterisk-users > _______________________________________________ Asterisk-Users mailing list [EMAIL PROTECTED] http://lists.digium.com/mailman/listinfo/asterisk-users To UNSUBSCRIBE or update options visit: http://lists.digium.com/mailman/listinfo/asterisk-users
