HI, I have been pulling my hair out trying to get a Cisco MC3810 to interface my Asterisk box with a T1. I am able to make outgoing calls but incoing calls never reach my Asterisk box. The cisco give a fast busy when I try to call one of the DID's. When playing around with the dial-peers I can get the cisco to pick up the call, but then it forwards the call back to the ANI that is dialing. I know the T1 is good because I hooked it up to a Nortel KSU and the DID's work fine.
I am receiving 4 digits and the T1 only has 4 ds0's. I have attached a sho run, any help would be appreciated. TIA, Jason service timestamps debug uptime service timestamps log uptime service password-encryption ! hostname gw1 ! boot-start-marker boot system tftp mc3810-a2isv5-mz.123-10a.bin 192.168.5.104 boot-end-marker network-clock base-rate 56k no aaa new-model ip subnet-zero ! voice class codec 10 codec preference 1 g711ulaw codec preference 2 g711alaw codec preference 4 g729r8 codec preference 6 g729ar8 ! ! no voice confirmation-tone ! controller T1 0 mode cas framing esf linecode b8zs ds0-group 1 timeslots 1-4 type e&m-wink-start fdl both ! controller T1 1 mode cas framing esf linecode b8zs ds0-group 1 timeslots 1-4 type e&m-wink-start ! ! ! interface Tunnel1 no ip address ! interface Ethernet0 ip address xx.xx.xx.xx 255.255.255.248 ! interface Serial0 no ip address shutdown ! interface Serial1 no ip address shutdown ! interface FR-ATM20 no ip address shutdown ! ip default-gateway xx.xx.xx.xx ip classless ip route 0.0.0.0 0.0.0.0 xx.xx.xx.xx no ip http server ! ! ! snmp-server community xxxxxx RO ! voice-port 0:1 ! voice-port 1:1 ! ! ! dial-peer voice 1 voip destination-pattern T progress_ind setup enable 3 progress_ind progress enable 8 voice-class codec 10 session protocol sipv2 session target ipv4:xx.xx.xx.xx session transport udp dtmf-relay rtp-nte no vad ! dial-peer voice 110 pots incoming called-number .... direct-inward-dial ! dial-peer voice 100 pots destination-pattern ....... port 0:1 ! sip-ua retry invite 3 retry cancel 2 sip-server ipv4:xx.xx.xx.xx:5060 ! ! line con 0 transport preferred all transport output all line aux 0 transport preferred all transport output all line 2 3 transport preferred all transport output all line vty 0 4 login local transport preferred all transport input all transport output all ! ntp server xx.xx.xx.xx end gw1# _______________________________________________ Asterisk-Users mailing list [EMAIL PROTECTED] http://lists.digium.com/mailman/listinfo/asterisk-users To UNSUBSCRIBE or update options visit: http://lists.digium.com/mailman/listinfo/asterisk-users
