Am I supposed run ztcfg before loading the drivers? Or is it just a utility to verify that they were loaded?
The results are below:
[EMAIL PROTECTED]:~# ztcfg -v
Zaptel Configuration ======================
SPAN 1: ESF/B8ZS Build-out: 0 db (CSU)/0-133 feet (DSX-1)
24 channels configured.
[EMAIL PROTECTED]:~#
Is that what it's supposed to look like?
Thanks for your help!
-Vickers
Peter Svensson wrote:
On Mon, 29 Nov 2004, Mark F. Vickers wrote:
According to the FAQ "When you load the module and have no circuit/channel bank the LED's should flash red"
I get the "knight rider" lights before the module loads, but after the modules are loaded I don't get any lights, other equipment plugged in or not.
Have you run ztcfg to load the zaptel.conf configuration into the driver?
Peter
_______________________________________________ Asterisk-Users mailing list [EMAIL PROTECTED] http://lists.digium.com/mailman/listinfo/asterisk-users To UNSUBSCRIBE or update options visit: http://lists.digium.com/mailman/listinfo/asterisk-users
_______________________________________________ Asterisk-Users mailing list [EMAIL PROTECTED] http://lists.digium.com/mailman/listinfo/asterisk-users To UNSUBSCRIBE or update options visit: http://lists.digium.com/mailman/listinfo/asterisk-users
