Hello, I have found a "bug", I think in the way TDM400P cards handle FXO interface disconnect/re-connect problems. Normally I do keep all the wires connected from my CO / PABX quite securely, but I had a need to re-route the cable from one side of the desk to another, and I simply disconnected the RJ-45 connector and plugged it back in. THIS PROMPTLY RESULTED IN VERY VERY SCRATCHY AUDIO CONNECTIONS WHEN USING THE FXO PORT. Incoming calls were erratic, outbound calls were almost unuseable, dialled digits were almost unrecognizable.
Basically after some difficult troubleshooting the fix was: before disconnecting cable kill asterisk process remove WCTDM module remove WCFXO module remove ZAPTEL module and then, reconnect cable, and then, install ZAPTEL, WCTDM, WCFXO, start asterisk once again. Apparently during operation of the zaptel driver, disconnect of the cables to the ports is not recommended. I can replicate this condition easily, and if other users have any trouble with their analog ports due to the fact that their connections are flaky after some change (while asterisk is running) I would love to know how they coped with it. -samudra --- Outgoing mail is certified Virus Free. Checked by AVG anti-virus system (http://www.grisoft.com). Version: 6.0.804 / Virus Database: 546 - Release Date: 11/30/2004 _______________________________________________ Asterisk-Users mailing list [EMAIL PROTECTED] http://lists.digium.com/mailman/listinfo/asterisk-users To UNSUBSCRIBE or update options visit: http://lists.digium.com/mailman/listinfo/asterisk-users