>Asterisk and it works fine untill the following >situation: > >- one of the telco lines occasionally becomes mute after call is completed, would not provide dial tone, (not sure about ringing on that >line) - both via old and new PBX. >- zap show channel <n> would show that line as 'Offhook', though no telephone is off hook. > >If physical line would be unplugged from TDM card, the line would become normal again.
The offhook in Zap Show Channels is only for FXS cards >Sorry, if it is a well known problem, but I did not find any specific information yet.. Please answer two questions: > > - is it really bad to have parallel connection on TDM400P FXO lines to an additional telephone equipment, does it prevent TDM400P to detect Offhook/Onhook correctly? I have equipment in parallel with no problems, which version of Asterisk are you running Which country are you in? Are you using CallerID facilities if so what signalling/method are you using? > - will the problems go away when parallel lines would be disconnected (legacy PBX shut down)? > >As you may understand the office personnel has anxiety that this may be a bad Asterisk setup / bad TDM card etc (which I am sure so far that it is not). Maybe but as I say I have not seen such problems. Did lines mute before Asterisk? Regards Ian _______________________________________________ Asterisk-Users mailing list [EMAIL PROTECTED] http://lists.digium.com/mailman/listinfo/asterisk-users To UNSUBSCRIBE or update options visit: http://lists.digium.com/mailman/listinfo/asterisk-users
