anynody knows if I Can install and run Asterisk under Free BSD? thanks,
Alvaro -----Mensaje original----- De: [EMAIL PROTECTED] [mailto:[EMAIL PROTECTED] nombre de Rich Adamson Enviado el: martes, 14 de diciembre de 2004 20:14 Para: Asterisk Users Mailing List - Non-Commercial Discussion; William Betts Asunto: Re: [Asterisk-Users] 404 "Not Found" Sip Response > The hardware I currently have is: > > TDM400P with 3 FXO ports, and 1 FXS port > 4 Cisco 7960 Phones (only 1 is currently configured for testing purposes) > Asterisk on slack 10 > > I can dial out just fine via the Cisco phone, but when I try to dail > in I get the following output when I load asterisk up in debug mode. > > -- Got SIP response 404 "Not Found" back from <ip_address_of_sip_phone> > -- SIP/20-e3a9 is circuit-busy > > I have looked several places for an answer to this and I haven't found > one. Any input from the users on this would be a great help. Here is > what is in my sip.conf and extensions.conf file. > > Thank You, > William Betts > > [general] > port=5060 > bindaddr=0.0.0.0 > tos=lowdelay > disallow=all > allow=ulaw > context=local-access > > [20] > type=friend > username=w0 > secret=m3 > host=64.123.157.103 > canreinvite=no > qualify=200 > disallow=all > allow=ulaw > allow=alaw > allow=g729 > callerid=Daves Office <20> > > > > [extensions] > exten => 20,1,Dial(SIP/20,20) > exten => 20,2,Voicemail(u${EXTEN}) > exten => 20,3,Hangup > exten => 20,102,Voicemail(b${EXTEN}) > exten => 20,103,Hangup > > [incoming] > > exten => s,1,Answer > exten => s,2,DigitTimeout(10) > exten => s,3,ResponseTimeout(20) > exten => s,4,Dial(SIP/20,20) > exten => t,1,Hangup > include => extensions Assuming that you have context=incoming on your fxo channels in zapata.conf, then the above context=incoming should be okay for starters. In your sip.conf file, the type=friend should not have host=64.123.157.103, as 'friend' implies the phone is registering with asterisk and therefore asterisk knows the IP from that registration. In sip.conf, your start out with context=local-access and then define extension 20 within "that" context. But, in extensions.conf you don't have any definitions for [local-access]. It kind of looks like you should change context=local-access to context=extensions in your extensions.conf file. If you can't make the phone operate without the host= statement, then debug why the phone isn't registering correctly. _______________________________________________ Asterisk-Users mailing list [EMAIL PROTECTED] http://lists.digium.com/mailman/listinfo/asterisk-users To UNSUBSCRIBE or update options visit: http://lists.digium.com/mailman/listinfo/asterisk-users _______________________________________________ Asterisk-Users mailing list [EMAIL PROTECTED] http://lists.digium.com/mailman/listinfo/asterisk-users To UNSUBSCRIBE or update options visit: http://lists.digium.com/mailman/listinfo/asterisk-users
