Mamadou Lamine KA wrote:
As you have a TDM400 you should load wcfxs module ( modprobe wcfxs or modprobe wctdm for new versions) regardless to modules you have installed on your board. You should also check the signalling specified in zaptel.conf according to your modules and the order they are placed on your TDM400.
Best regards Lamine
----- Original Message ----- From: "Steven P. Donegan" <[EMAIL PROTECTED]> To: <[email protected]> Sent: Monday, December 27, 2004 6:01 PM Subject: [Asterisk-Users] TDM400 problem
I recently swapped 2 FXO modules on to what had previously been a 4 FXS version of the TDM400 board. The FXS ports are recognized - the FXO ports don't appear to be recognized (ie modprobe wcfxo and ztcfg both say channel 1 isn't there). Has anyone experienced this problem? All software is current as of this AM. If the old FXS modules are re-installed all works just dandy (other than the fact that I need the 2 FXO ports)...
Thanks!
_______________________________________________ Asterisk-Users mailing list [email protected] http://lists.digium.com/mailman/listinfo/asterisk-users To UNSUBSCRIBE or update options visit: http://lists.digium.com/mailman/listinfo/asterisk-users
_______________________________________________ Asterisk-Users mailing list [email protected] http://lists.digium.com/mailman/listinfo/asterisk-users To UNSUBSCRIBE or update options visit: http://lists.digium.com/mailman/listinfo/asterisk-users
modules are FXO and FXS - zapata.conf says fxoks=1-2 and fxsks=3-4
TDM is older unit with no apparent external power connectors (well, not a disk drive type one anyway) and no external power was required to use the FXS ports in the past...
_______________________________________________ Asterisk-Users mailing list [email protected] http://lists.digium.com/mailman/listinfo/asterisk-users To UNSUBSCRIBE or update options visit: http://lists.digium.com/mailman/listinfo/asterisk-users
