On Tue, 2004-12-28 at 23:18 -0600, Matthew Boehm wrote: > Hey gang, > I was successful in recompiling my 2.4.20 kernel to support HDLC. I was > successful in hooking up our T1 line into the zap card. I was successful in > being able to ping equipment on the other end of the T1. I was unsuccessful > in pinging the outside world from the other end of the T1. > > I've attached a cheezy image of the network. Here is the routing table:
And your cheezy network image shows you have not exhibited good networking knowledge. You show an internet clod in the middle of a point to point T1. > [EMAIL PROTECTED] root]# route > Kernel IP routing table > Destination Gateway Genmask Flags Metric Ref Use > Iface > 10.0.5.2 * 255.255.255.255 UH 0 0 0 > hdlc0 > 10.0.0.0 * 255.255.255.0 U 0 0 > 0 eth1 Why is it you have 10.0.0.2 as a IP on the other end of a router on the T1 line and you are routing it out of the eth1 device. > 10.0.3.0 * 255.255.255.0 U 0 0 > 0 eth1 > 65.78.109.0 * 255.255.255.0 U 0 0 0 > eth0 > 127.0.0.0 * 255.0.0.0 U 0 0 > 0 lo > default 65.78.109.2 0.0.0.0 UG 0 0 > 0 eth0 > > There are 2 NICs (10.0.3.10, 65.78.109.10) and 1 T100P (10.0.5.1) on this > box. > I'm a little stumped. My iptables are completly empty. If this is waaayyy > off topic, please contact me off list. But I figured since it was related to > the T100P it might be relevant. It just appears you have routing issues not anything related to the T100P card. The T100P card is passing traffic as it should and is no longer even a portion of your problem. You are into higher level protocols. -- Steven Critchfield <[EMAIL PROTECTED]> _______________________________________________ Asterisk-Users mailing list [email protected] http://lists.digium.com/mailman/listinfo/asterisk-users To UNSUBSCRIBE or update options visit: http://lists.digium.com/mailman/listinfo/asterisk-users
