That was it. I compiled them in the wrong order. You know sometimes it really pays to read the instructions
________________________________ From: [EMAIL PROTECTED] on behalf of Jerry Rasmussen Sent: Wed 12/29/2004 3:56 PM To: Asterisk Users Mailing List - Non-Commercial Discussion Subject: RE: [Asterisk-Users] zapata.conf not being parsed by * You know I think the I compiled them in the wrong order. I bet you that is it. I will give it a try and let you know. ________________________________ From: [EMAIL PROTECTED] on behalf of Eric Wieling aka ManxPower Sent: Wed 12/29/2004 3:39 PM To: Asterisk Users Mailing List - Non-Commercial Discussion Subject: Re: [Asterisk-Users] zapata.conf not being parsed by * Jerry Rasmussen wrote: > Also when I try to dial outbound I get the following errors > channel.c:1920 ast_request: No channel type registered for 'Zap' and > Unable to create channel of type 'Zap' (cause 66). My assumption is I am > getting these errors because Zapata.conf is not being parsed Or you have a noload => chan_zap.so in /etc/asterisk/modules.conf or you installed Asterisk before you installed zaptel. Install zaptel before you install Asterisk or the chan_zap modules won't be built. You should also confirm that ztcfg -vvv shows your card and the correct ports. --Eric _______________________________________________ Asterisk-Users mailing list [email protected] http://lists.digium.com/mailman/listinfo/asterisk-users To UNSUBSCRIBE or update options visit: http://lists.digium.com/mailman/listinfo/asterisk-users
<<winmail.dat>>
_______________________________________________ Asterisk-Users mailing list [email protected] http://lists.digium.com/mailman/listinfo/asterisk-users To UNSUBSCRIBE or update options visit: http://lists.digium.com/mailman/listinfo/asterisk-users
