Hi All, I fixed the missed IRQ's with the following reference: http://lists.digium.com/pipermail/asterisk-users/2004-July/054712.html
At 01:09 AM 26/01/2005, you wrote:
Hi All,
I have a TE110P in E1 mode, in a dell poweredge 250.
The 30 channel E1 supplied is from a telco in Australia, with the following in my zaptel.conf:
span=1,1,0,ccs,hdb3 bchan=1-15 dchan=16 bchan=17-31
(yes the provider has NOcrc4 for some reason)
After installing the latest cvs libpri and zaptel, I successfully loaded the kernel modules.
The card is verified as not sharing an interrupt with anything else.
The problem is I continuously get yellow errors, the IRQ missed counter goes up, and
the light on the card blinks b/w red and green.
I have verified the cabling, as it works fine in the E1 port of a cisco router below it.
Any ideas most welcome thanks.
TIA
_______________________________________________ Asterisk-Users mailing list [email protected] http://lists.digium.com/mailman/listinfo/asterisk-users To UNSUBSCRIBE or update options visit: http://lists.digium.com/mailman/listinfo/asterisk-users
All the best, Brett Murphy Director, Alphalink (Australia) PTY LTD ph: +61 3 9495-9000 fax: +61 3 9486-6822 email: [EMAIL PROTECTED]
The contents of this message may not be quoted, copied, reproduced or published in part or in whole, without the written authorization of Brett Murphy, Director, Alphalink (Australia) Pty Ltd.
_______________________________________________ Asterisk-Users mailing list [email protected] http://lists.digium.com/mailman/listinfo/asterisk-users To UNSUBSCRIBE or update options visit: http://lists.digium.com/mailman/listinfo/asterisk-users
