Try looking in your extensions.conf file. If you are using ports 0 and 2 then you should see somewhere in there something like zap/1 and zap/4 and those should tied to the dial commands.
Hopefully these have been configure in the globals section of the extensions.conf. I am kind of a newb at this so if this is not clear, feel free to fire away with questions. Robert -----Original Message----- From: [EMAIL PROTECTED] [mailto:[EMAIL PROTECTED] On Behalf Of David Newman Sent: Monday, January 31, 2005 2:09 PM To: asterisk-users@lists.digium.com Subject: [Asterisk-Users] line assignment on TDM400P Greetings. We are running * on RH9 using a Digium TDM400P four-port FXO card. We use only two ports on the card (ports 0 and 2 in this case). A consultant set this up for us, and it mostly works OK. However, outbound calls use our secondary number rather than our primary number first. This undesirable because of Caller ID; we'd like the primary number to appear instead. Yes, I can correct this by swapping the PSTN lines. But which config file assigns the physical FXO ports to PSTN lines? In other words, what file would I alter to assign different lines to each port? thanks dn _______________________________________________ Asterisk-Users mailing list Asterisk-Users@lists.digium.com http://lists.digium.com/mailman/listinfo/asterisk-users To UNSUBSCRIBE or update options visit: http://lists.digium.com/mailman/listinfo/asterisk-users _______________________________________________ Asterisk-Users mailing list Asterisk-Users@lists.digium.com http://lists.digium.com/mailman/listinfo/asterisk-users To UNSUBSCRIBE or update options visit: http://lists.digium.com/mailman/listinfo/asterisk-users
