I have noticed the following: - the PCI ID of the card seems to change over time which means that loading the module does not always recognise the card, only way to reset this is to power cycle the machine
- you cannot unload the module once it is loaded, it hangs the machine, which also means if you have automatic shutdown scripts for restarting the machine then the machine will hang on reboot One of the LEDs shows the status of the connection. If it is off, then it is not active, i.e. zaptel drivers not loaded. If red then bad connection i.e. it is not talked to the other end, usually a wiring problem If green then everything OK. Could also be a yellow state but I haven't seen that. Once you get it working, leave the thing up is my only advice. It is a shame that it is not bug free, neither the hardware nor the software so far. I don't know what Digium want to do about the hardware. I hope there is a firmware fix rather than having to mess with the actual physical hardware. _______________________________________________ Asterisk-Users mailing list [email protected] http://lists.digium.com/mailman/listinfo/asterisk-users To UNSUBSCRIBE or update options visit: http://lists.digium.com/mailman/listinfo/asterisk-users
