----- Original Message ----- From: "C F" <[EMAIL PROTECTED]>
To: "Asterisk Users Mailing List - Non-Commercial Discussion" <[email protected]>
Sent: Monday, March 28, 2005 3:57 PM
Subject: Re: [Asterisk-Users] Cisco 7940 and multiple simultaneous calls
On Mon, 28 Mar 2005 10:31:56 -0600, Henry Devito <[EMAIL PROTECTED]> wrote:Hate to bring up an old thread. I just configured a 7960 with multipleWell it works for me and many others, so obviously..........
lines appearing. Each defined the same, but the buttons don't seem to roll
over. What else do I have to define to do this.
So lets begin:
1. I found out (the hard way), that if you configure button 1 with sip
account a, and button 2 with sip account b, then you can't try this
(using sip account a) on button 3, it has to be in order (I didn't
design it).
2. Make sure call waiting is disabled, although some suggested that it
is not required, since you are asking me, and this is how I have it
setup, and I never tested it any other way, give it a try.
3. Sometimes if you use the buttons on the phone and not TFTP to
configure the phone, you might mistake what parameteres to match to
the first button, therefore try making everything the same if
possible.
_______________________________________________
Asterisk-Users mailing list
[email protected]
http://lists.digium.com/mailman/listinfo/asterisk-users
To UNSUBSCRIBE or update options visit:
http://lists.digium.com/mailman/listinfo/asterisk-users
_______________________________________________ Asterisk-Users mailing list [email protected] http://lists.digium.com/mailman/listinfo/asterisk-users To UNSUBSCRIBE or update options visit: http://lists.digium.com/mailman/listinfo/asterisk-users
