Dido Sevilla wrote:
I've been struggling with getting the soft-switch.org Unicall/MFC-R2
implementation working. After wading through some misleading
instructions and a build process that leaves much to be desired in
terms of reliability and consistency (e.g., the order in which the
various libraries should be compiled is plain wrong: I believe it
should be spandsp, supertone, unicall, and mfcr2 in that order) , I've
finally managed to get a working chan_unicall.so module used by
Asterisk. From searching through the mailing list archives, I see
that I seem to have gone a good deal of the way, up to the point where
I see the "warnings" about channels being unblocked on the near and
far ends when * starts. However, when I attempt to initiate an
outbound call with Asterisk, it suddenly fails with what I gather is a
congestion error. "no one is available to answer at this time".
I am quite certain it is not a problem with the E1R2 we are using, as
it had previously been in use on a Nortel PBX and was working fine
there. I'm trying to use the Philippine R2 variant.
Does anyone have a sample configuration that works for the
Philippines? Any help on this is much appreciated.
You attitude in this message has just ensured you that if you have any
problems you are entirely on your own.
Bye bye
Steve
_______________________________________________
Asterisk-Users mailing list
[email protected]
http://lists.digium.com/mailman/listinfo/asterisk-users
To UNSUBSCRIBE or update options visit:
http://lists.digium.com/mailman/listinfo/asterisk-users
