Hello Victor:
Are you using the QuadBRI from Junghanns?
If so, this is a configuration that works for me in the UK, one single E1 board and the QuadBRI. As I recall, the order of loading is important (see way below):
ZAPTEL.CONF
loadzone=nl defaultzone=nl
# qozap span definitions # most of the values should be bogus because we are not really zaptel span=1,1,3,ccs,ami span=2,0,3,ccs,ami span=3,0,3,ccs,ami span=4,0,3,ccs,ami
# E1 definition: span=5,0,0,ccs,hdb3,crc4
#BRI's: bchan=1,2 dchan=3 bchan=4,5 dchan=6 bchan=7,8 dchan=9 bchan=10,11 dchan=12
#E1: bchan=13-27,29-43 dchan=28 ---------------------------------------------------------------------------------------------
ZAPATA.CONF
[channels] ; ; Default language ; ;language=en ; ; Default context ; ; switchtype = euroisdn
; p2mp TE mode (for connecting ISDN lines in point-to-multipoint mode) signalling = bri_cpe_ptmp
; define 4 BRI's: pridialplan = unknown prilocaldialplan = unknown echocancel = yes context=incoming group = 1 channel => 1-2 group = 2 channel => 4-5 group = 3 channel => 7-8 group = 4 channel => 10-11 group = 9
;and the E1
pridialplan = unknown
signalling=pri_net <- this is because I'm connecting to a Dialogic board
in another system, not the PSTN.. Would normally be pri_cpe
channel => 13-27,29-43
---------------------------------------------------------------------------------------------
IN YOUR SYSTEM REBOOT ROUTINE:
#following for Quad BRI system: cd /usr/src/bri/bri-stuff.0.1.0-RC2g/qozap modprobe -v zaptel >>/var/log/asterisk/modprobe.log sleep 1 insmod -v qozap.o >>/var/log/asterisk/modprobe.log sleep 1
# following for single E1 system modprobe -v wct1xxp >>/var/log/asterisk/modprobe.log sleep 4
#ztcfg -vv >>/var/log/asterisk/modprobe.log <- NOTE THAT ztcfg commented out, Junghanns issue
#sleep 3
startast
sleep 3
GOOD LUCK Scott Stingel
www.evtmedia.com
-------------------------------------------------
Victor Alvarez wrote:
Hello,
I have a machine with two cards installed, one digium that gives e1 connectivity and one quadBri for the ISDN line.
I can use them independently. I have one zaptel.conf and one zapata.conf for each card. I would like to work with them at the same time and I am not sure about how could I do it (if it is possible!). My first attempt wasn't very successful. I made the config files getting the info from the one for isdn and the one for e1. Ztcfg configures the 136 channels without problems but I can't use the e1 channel. A curious thing is that, with the same configuration, I can use the e1 channel.
Any help/suggestion is more than welcome.
Thanks.
------------------------------------------------------------------------
_______________________________________________ Asterisk-Users mailing list [email protected] http://lists.digium.com/mailman/listinfo/asterisk-users To UNSUBSCRIBE or update options visit: http://lists.digium.com/mailman/listinfo/asterisk-users
_______________________________________________ Asterisk-Users mailing list [email protected] http://lists.digium.com/mailman/listinfo/asterisk-users To UNSUBSCRIBE or update options visit: http://lists.digium.com/mailman/listinfo/asterisk-users
