>What do you have to do to get * to see the TDM400P? It sees the PRI card and associated channels >but I can't get the TDM400P to work - no matter what mix of channel numbers I use ztcfg doesn't >like it.
My config with a Digium PRI card and a TDM400P, just finished yesterday & working fine: zaptel.conf: span=1,2,0,esf,b8zs <--Ususally Timing parameter is set to 1 here, but I am using 2 bchan=1-23 dchan=24 fxoks=25-28 <---I have 4 FXS cards and I want them as ZAP/25-28 zapata.conf: [channels] language=en context=from-pstn switchtype=national pridialplan=unknown <--this is an imporant parameter; it's best to set it as "unknown" this tripped me up before signalling=pri_cpe usecallerid=yes echocancel=yes group=0 channel=1-23 <--Note the absence of Channel 24, the D-channel. Used for signalling, so leave it alone. context=from-internal <--I use AMP so I want the users cordless phones etc to work in the same context as the SIP phones signalling=fxo_ks <--- Note FXO parameter here; don't forget FXS cards use FXO signalling & vice-versa usecallerid=yes group=0 <--Same group for AMP use channel=25-28 /etc/rc.d/rc.local: <--I use rc.local instead of starting it as a service, this lets me specify the load order. Personal preference. modprobe wct1xxp modprobe wcfxs modprobe zaptel ztcfg -vv <--I want the console to display what's going on. /usr/sbin/ampportal start <--optionally, you could do "su asterisk /usr/sbin/safe_asterisk & " if you are not using AMP Last note: cron a reboot every night otherwise your TDM400 will crap out on you after a week or so. Much speculation on the list as to why. Reboot fixes it. HTH _______________________________________________ Asterisk-Users mailing list [email protected] http://lists.digium.com/mailman/listinfo/asterisk-users To UNSUBSCRIBE or update options visit: http://lists.digium.com/mailman/listinfo/asterisk-users
