I own elmeg C46e PBX (ISDN PBX with 6 a/b ports). I
connected two of these ports to a TDM02B installed on a Slackware 9.1/
Asterisk 1.0.2 and I bought a Cisco ATA186 to connect two analog
telephone sets two floors down. Each a/b port is assigned only to one
ATA port. The problem is that after the first call, the Digium card
fails to disconnect the lines and I keep getting the busy signal. What
is more strange is that when I connect the same equipment to two POTS
lines of the telco, all run smoothy. Any ideas anyone? How should
I setup my line (eg as fxs_ks or something else?)
Dimitris Kouimintzis
_______________________________________________
Asterisk-Users mailing list
[email protected]
http://lists.digium.com/mailman/listinfo/asterisk-users
To UNSUBSCRIBE or update options visit:
http://lists.digium.com/mailman/listinfo/asterisk-users
