BTW, you hijacked someone's thread...
Try this:
-- sip.conf --
register => 5595551212:[EMAIL PROTECTED]/5595551212
[broadvoice-in] type=peer host=sip.broadvoice.com context=broadvoice-inbound canreinvite=no qualify=yes nat=no
-- extensions.conf --
[broadvoice-inbound]
exten => 5595551212,1,Goto(default,s,1)
###
MARK.
Brian Watters wrote:
Johnathan,
Thanks for your reply ..
[EMAIL PROTECTED]:somethinginnocuous:[EMAIL PROTECTED] advoice.com
Note when I attempt to use "sip debug" from the CLI I get
[EMAIL PROTECTED] /]# sip debug
-bash: sip: command not found
[EMAIL PROTECTED] /]#
However via the Web GUI I can see the following ..
Sip Peers Host Username Refresh State sip.broadvoice.com:5060 [EMAIL PROTECTED] 3584 Registered Verbosity is at least 3
Sip Registry Name/username Host Dyn Nat ACL Mask Port
Status bv/5594734514 147.135.8.128 N 255.255.255.255 5060 OK
(60 ms)
500/500 (Unspecified) D 255.255.255.255 0
Unmonitored
300/300 (Unspecified) D 255.255.255.255 0
Unmonitored
Verbosity is at least 3
Like I said I am able to make outbound calls no issue .. I assume this would mean that outbound I and able to register with BroadVoice?
Any ideas?
BRW
-----Original Message-----
From: Johnathan Corgan [mailto:[EMAIL PROTECTED] Sent: Tuesday, April 12, 2005 6:42 PM
To: [EMAIL PROTECTED]; Asterisk Users Mailing List - Non-Commercial
Discussion
Subject: Re: [Asterisk-Users] BroadVoice Inbound Not working ..
Brian Watters wrote:
Ok .. It appears we have outbound calls working well via our SIP trunk and BroadVoice .. However inbound just plain does not work, What happens is when you call our BroadVoice number it tells you the person you are calling is not available .. Never makes it to our Asterisk? .. Any ideas where to look and or what to tweak?
If the incoming SIP connection really isn't making it to your Asterisk (verify with 'sip debug' command on console), it is likely because BV doesn't know where to connect to.
* accomplishes this by a process called "registration." In your sip.conf, near the top in the [general] section, you should have a line that starts out:
register =>
If this is there, can you send it (and change the password to something innocuous?)
If this line is there, you can see whether it succeeded by typing 'sip show registry' at the console.
If that shows the state of registered, and your sip debug output shows an in coming connection request from BV, then there are further steps for debugging, but start with the above.
-Johnathan
_______________________________________________
Asterisk-Users mailing list
[email protected]
http://lists.digium.com/mailman/listinfo/asterisk-users
To UNSUBSCRIBE or update options visit:
http://lists.digium.com/mailman/listinfo/asterisk-users
_______________________________________________ Asterisk-Users mailing list [email protected] http://lists.digium.com/mailman/listinfo/asterisk-users To UNSUBSCRIBE or update options visit: http://lists.digium.com/mailman/listinfo/asterisk-users
