On Fri, 22 Apr 2005 11:48:18 -0400 Mark Phillips <[EMAIL PROTECTED]> wrote:
Nothing happens. I get the same (non)error.
I get plenty of output when receiving a call however.
Mark
Andrew Kohlsmith wrote:On April 22, 2005 10:41 am, Robert Webb wrote:
Your zapata.conf should look like this:
language=en context=default switchtype=4ess pridialplan=unknown signalling=pri_cpe echocancel=yes group=1 channel=>1-23
You need to move the echocancel and the group above the channel line. The channel line definitions must be above and not below.
You're right, but that's not his problem. Cause code 0 is no cause code at all; I'd turn on "pri debug span 1" output and see what's coming up there.
-A.
I am grasping at straws here, but have you tried it without the pridialplan command?? According to the wiki, this really doesn't need to be there.
pridialplan: Sets an option required for some (rare) switches that require a dialplan parameter to be passed. This option is ignored by most PRI switches. It may be necessary on a few pieces of hardware. Valid options are: unknown, local, private, national, and international. This option can almost always be left unchanged from the default. Default: national.
pridialplan=local _______________________________________________ Asterisk-Users mailing list [email protected] http://lists.digium.com/mailman/listinfo/asterisk-users To UNSUBSCRIBE or update options visit: http://lists.digium.com/mailman/listinfo/asterisk-users
