The 7.x firmware has two loads. You need to load the P00 load first, then reboot and load the P0S load second. Cisco introduced an application loader into the 7.x firmware.
Here's what I do: 1.) load version 5.3 - bin file 2.) load the 7.4 P00 load (application loader) - sbn file 3.) load the 7.4 P0S load (final upgrade) - sb2 file If you just load the loader, the phone will reboot and may even uninstall the imcomplete load. If you attempt to load the P0S without the app loader, it will reboot and uninstall. Good luck. -SG -----Original Message----- From: Ken Seefried [mailto:[EMAIL PROTECTED] Sent: Monday, May 09, 2005 3:35 PM To: [email protected] Subject: RE: [Asterisk-Users] cisco 7960 firmware From: "Terry Wade" <[EMAIL PROTECTED]> > If memory serves correctly. You need to go from firmware version 3 to 4 to 5 > and then you can jump to 7. or something like that. I just did this upgrade today. I went from 3.<something> to 5.0. When I tried to go to 7.4, the phone would continually try to upgrade and then reboot without finishing. I went to 6.3 without issues, but still couldn't go to 7.x (same symptoms). I googled a note that mentioned the continual reboot issue, and said the solution was to remove all of the comments and blank lines from SIPDefaults.cnf. Once I did this, I could upgrade to 7.0 and then 7.4. Ken _______________________________________________ Asterisk-Users mailing list [email protected] http://lists.digium.com/mailman/listinfo/asterisk-users To UNSUBSCRIBE or update options visit: http://lists.digium.com/mailman/listinfo/asterisk-users _______________________________________________ Asterisk-Users mailing list [email protected] http://lists.digium.com/mailman/listinfo/asterisk-users To UNSUBSCRIBE or update options visit: http://lists.digium.com/mailman/listinfo/asterisk-users
