zaptel/asterisk is counting from 1, so 1-16 is D-channel of first E1 interface.
See archive for thread named "Asterisk and Cisco AS5300 or 3600". There is example of configuration.
-b
----- Original Message ----- From: "Asterisk" <[EMAIL PROTECTED]>
To: "Asterisk Users Mailing List - Non-Commercial Discussion" <[email protected]>
Sent: Monday, May 16, 2005 2:18 PM
Subject: [Asterisk-Users] cisco 3620 setup (newbie cisco alert)
I'm experimenting (using for the first time) with using a cisco3620 to connect to the PSTN via a channelised E1 interface, with * handling all of the SIP calls.
If anyone has any installation tips / help / documentation I would be most appreciative :)
However, my first question is this: when I am in the setup, I see the following:
Current interface summary
Controller Timeslots D-Channel Configurable modes Status E1 0/0 31 15 pri/channelized Administratively up E1 1/0 31 15 pri/channelized Administratively up
I have set both controllers to hdb3, ccs with crc4
I notice that the D-Channel is set to 15. However, in the zaptel.conf file I use with my TE410p card, the D-Channel is set to 16. So, is cisco counting 0-14 (hence 15 is the D-Channek) and zaptel counting from 1-15 (and therefore 16 is the D-channel) ? Or is my config wrong on the cisco or zaptel ??
Any help would be welcome. Thanks !
Julian _______________________________________________ Asterisk-Users mailing list [email protected] http://lists.digium.com/mailman/listinfo/asterisk-users To UNSUBSCRIBE or update options visit: http://lists.digium.com/mailman/listinfo/asterisk-users
_______________________________________________ Asterisk-Users mailing list [email protected] http://lists.digium.com/mailman/listinfo/asterisk-users To UNSUBSCRIBE or update options visit: http://lists.digium.com/mailman/listinfo/asterisk-users
