Also, if I want to use * to handle all of the SIP internal calls, and cisco to handle to inbound and outbound isdn-32 PRI calls, what "feature set" of the IOS should I need ? What hardware on the cisco 3620 should I need ? I've got a PRI-1CE1U and a WIC-1MFT-E1 and a two-port fast ethernet. I also have a 2610 to play with if required :)
Many thanks for your help. It is much appreciated. There is only so much a newbie can do without advice.
Julian.
barney wrote:
I can`t see voice-port in your configuration. Something like this:
!
voice-port 1/0:15 ; voice-port 1/0:15, if your D channel is Serial1/0:15
input gain -6
output attenuation 14
echo-cancel coverage 32
echo-cancel suppressor
cptone SK
description E1
bearer-cap Speech
!
If you configure voice-port, try again to configure dial-peer (port x/y:15 command) and if you have DSPs in you box, you must see something like this:
SIP-3640#show voice dsp
DSP DSP DSPWARE CURR BOOT PAK TX/RX
TYPE NUM CH CODEC VERSION STATE STATE RST AI VOICEPORT TS ABORT PACK COUNT
==== === == ======== ======= ===== ======= === == ========= == ===== ============
C549 000 00 {high} 3.4.56 IDLE idle 0 0 2/0:15 01 0 0/16
01 {high} 3.4.56 IDLE idle 0 2/0:15 17 0 0/0
C549 001 00 {high} 3.4.56 IDLE idle 0 0 2/0:15 02 0 0/16
01 {high} 3.4.56 IDLE idle 0 2/0:15 18 0 0/0
....
If you don`t have any DSP in your C3620, it will be unusable. So check it!
-b
_______________________________________________ Asterisk-Users mailing list [email protected] http://lists.digium.com/mailman/listinfo/asterisk-users To UNSUBSCRIBE or update options visit: http://lists.digium.com/mailman/listinfo/asterisk-users
