hello there,
i also using the same board and configure for the E1
before this i also got the same problem.
what the problem are:
1. cabling
2. and the zaptel.conf
span=1,1,0,ccs,hdb3,crc4
bchan=1-15,17-31 # set this to 1-15,17-31 for E1
dchan=16 # set this to 16 for E1
i get this from digium website and u must change a
little bit.
hopefully this will help u..
good luck..
--- Peter Svensson <[EMAIL PROTECTED]> wrote:
> On Tue, 24 May 2005, Remco Barende wrote:
>
> > I'm trying to setup a Wildcard TE110P with a PRI
> in The Netherlands.
> >
> > I get a Red Alarm on the line.
> >
> > Is there any way of debugging this? I've tried
> some configs that should
> > work but without success. Is there any way of
> telling if the cabling is
> > correct or what else the problem could be?
>
> Have you configured the card to E1 and not T1? Red
> alarm is usually a loss
> of carrier (or close enough most of the time). I.e.
> you are not seeing
> incoming signals from the remote end.
>
> Check thatthe card is set to E1, check the cabling
> and check that the
> remote end is up.
>
> Peter
>
>
> _______________________________________________
> Asterisk-Users mailing list
> [email protected]
>
http://lists.digium.com/mailman/listinfo/asterisk-users
> To UNSUBSCRIBE or update options visit:
>
>
http://lists.digium.com/mailman/listinfo/asterisk-users
>
__________________________________
Do you Yahoo!?
Yahoo! Small Business - Try our new Resources site
http://smallbusiness.yahoo.com/resources/
_______________________________________________
Asterisk-Users mailing list
[email protected]
http://lists.digium.com/mailman/listinfo/asterisk-users
To UNSUBSCRIBE or update options visit:
http://lists.digium.com/mailman/listinfo/asterisk-users
