|
You can build it alone.
Then try to 'modprobe zaptel' and then 'modprobe
ztdummy'
If you do this without errors it must
work.
For more info read the wiki.
RG,
Gentian
----- Original Message -----
Sent: Tuesday, May 31, 2005 12:22
PM
Subject: [Asterisk-Users] Ztdummy
usage
Dear All,
I have installed Asterisk everything is OK until I tried to configure
meeting room, configuration was simple enough when I try I get a message that
it's not a valid meeting room, Now I don't have a Zaptel device on my
machine, so I found that you will have to use ztdummy to make a dummy
zaptel device on your machine and this is because of timing issues.
My question is ztdummy can only be done when making asterisk or is ther a
way to do it after post installation?
I am using by the way freebsd 5.3, built Asterisk from the ports
successfully. --
Thx
MAG
_______________________________________________
Asterisk-Users
mailing
list
[email protected]
http://lists.digium.com/mailman/listinfo/asterisk-users
To
UNSUBSCRIBE or update options visit:
http://lists.digium.com/mailman/listinfo/asterisk-users
|
_______________________________________________
Asterisk-Users mailing list
[email protected]
http://lists.digium.com/mailman/listinfo/asterisk-users
To UNSUBSCRIBE or update options visit:
http://lists.digium.com/mailman/listinfo/asterisk-users
