|
Would something as simple as this work? [InFromZap1] ;Context
for incoming telco calls exten => 1234567890, 1, Dial(Zap/g2) ;g2
would be the second digium card connected to our Lucent PM3 with a crossover
cable. Thanks Adam From: [EMAIL PROTECTED]
[mailto:[EMAIL PROTECTED] On Behalf Of Adam Vocks We’re still using Lucent PM3’s Adam From:
[EMAIL PROTECTED]
[mailto:[EMAIL PROTECTED] On Behalf Of Alexander Lopez This may or may not work due to timings
slips that you may experiance with the Digium Cards. Your are correct in
assuming this scenaro. I did the same (pre-asterisk) with an
Adtran Atlas. It is rock solid and works great. What modem access
bank are you using, there has been some talk about using the PM3 as an IAX
gateway. (highly vaporware at this point), The Acend unit support SIP, the
Cisco suport..., etc. etc, From: [EMAIL PROTECTED]
[mailto:[EMAIL PROTECTED] On Behalf Of Adam Vocks In an order to save money, I would like to use a PRI that we
have going to one of our dial-up modem banks (We are an ISP.) During
business hours these channels are idle and during our peak internet times, we
are closed. Sounds too good to be true, but I thought I would throw it
out there. These are modem calls that if they would call our modem bank
number, they would be bridged to the outbound zap channels??? And of
course, if they dial our business number we would send them to the appropriate
sip channels. I didn’t know if this could be done with two T1 cards
and asterisk… Here is a primitive sketch.
If anyone has information, please share. Thank You Adam Vocks CTI |
_______________________________________________ Asterisk-Users mailing list [email protected] http://lists.digium.com/mailman/listinfo/asterisk-users To UNSUBSCRIBE or update options visit: http://lists.digium.com/mailman/listinfo/asterisk-users
