----- Original Message -----
From: "Ralf Schlatterbeck" <[EMAIL PROTECTED]>
To: "Asterisk Users Mailing List - Non-Commercial Discussion"
<[email protected]>
Sent: Sunday, June 05, 2005 6:22 AM
Subject: Re: [Asterisk-Users] X100P installed OK,after added TDM400P
Asterisk would no longer start
On Sat, Jun 04, 2005 at 11:20:47PM +0100, Angus Comber wrote:
This is what I have:
# Span 1: WCTDM/0 "Wildcard TDM400P REV H Board 1"
fxoks=1
fxoks=2
fxoks=3
# channel 4, WCTDM, inactive.
# Span 2: WCFXO/0 "Wildcard X101P Board 1"
fxsks=5
# Global data
loadzone = us
defaultzone = us
Which from your response appears correct.
Could it have confused the cards? If I swap them in the config might
that
work?
Depends on the order you load the drivers I think. So swapping them in
the config will probably help, yes. The FXS modules would then be 5-7
and the FXO 1...
You really have two boards, one with 3 FXS modules and one with a single
FXO module?
In the end I just removed the X100P board. I want to buy a four port analog
trunk card and use this for real anyway. I suspect however that if I had
swapped the cards in the config it might have worked.
Angus
Ralf
--
Ralf Schlatterbeck
email: [EMAIL PROTECTED] FAX: +43/2243/26465/23
_______________________________________________
Asterisk-Users mailing list
[email protected]
http://lists.digium.com/mailman/listinfo/asterisk-users
To UNSUBSCRIBE or update options visit:
http://lists.digium.com/mailman/listinfo/asterisk-users
_______________________________________________
Asterisk-Users mailing list
[email protected]
http://lists.digium.com/mailman/listinfo/asterisk-users
To UNSUBSCRIBE or update options visit:
http://lists.digium.com/mailman/listinfo/asterisk-users
