The connection goes directly from the Sipura to the handset over a standard 6ft grey cable. I've tried a few different cables.
With no handset connected, it sitting at 100VAC. I guess the ring generator isn't working. On Tue, 19 Jul 2005, Jim Van Meggelen wrote: > [EMAIL PROTECTED] wrote: > > It does default to 25hz, but switching it to 20hz didn't make > > a difference. > > It was a long shot. Still. 20Hz is correct, so might as well leave it > that way > > > I'm an absolute novice when it comes to the electrical side > > of POTS. How should I be measuring the voltage? In parallel > > with a handset? > > No need to have anyting on the end of the line. Connect a voltmeter to > tip and ring (doesn't matter which polarity you connect - one probe to > each contact), and go from there. The voltage will be there regardless > of whether any phones are connected to the circuit. If you cannot detect > any voltage (or it's well below 70VAC), that'll explain why the sets > won't ring. > > Are you plugging directly into the FXS port on the Sipura? No cabling or > anything involved? > > Jim. > > > > > On Tue, 19 Jul 2005, Jim Van Meggelen wrote: > > > >> Simon P. Ditner wrote: > >>> Is there some trick I'm missing that's required to get the > >>> Sipura 1001 FXS to ring a handset? > >>> > >>> - I reset the unit to factory defaults > >>> - I put in the asterisk connection settings, and it registers > >>> - I call it from another phone, and see it come through > >>> asterisk > >>> - web interface of the sipura reports that the line is > >>> ringing > >>> - No handset I plug into the bugger will ring, though the > >>> call is there if I pick it up > >> > >> Change the ringing frequency from 25Hz to 20Hz. Some of the > >> Sipuras default to 25Hz, but in NA the norm is 20Hz. It > >> generally shouldn't make a difference, but on some phones > >> (especially older ones) it might. > >> > >> Also, check with a volt meter that you're getting ringing > >> voltage (roughly 70-90VAC). Possibly the ring generator in > >> the unit is blown. > >> > >> Jim. > >> > >> > >> -- > >> Jim Van Meggelen > >> [EMAIL PROTECTED] > >> http://www.oreillynet.com/pub/au/2177 > > > -- > No virus found in this outgoing message. > Checked by AVG Anti-Virus. > Version: 7.0.323 / Virus Database: 267.9.1/51 - Release Date: 18/07/2005 > > > > --------------------------------------------------------------------- > To unsubscribe, e-mail: [EMAIL PROTECTED] > For additional commands, e-mail: [EMAIL PROTECTED] > >
