Thanks for the response Ian.

I couldn't quite figure out where to put this code.
I am using [EMAIL PROTECTED] 2.5.

I added this section to my extensions_custom.conf

[ext-did-custom]

exten => 8883335555,1,Set(CALLERID(name)=Fishburn)

exten => 8883335555,2,Set(CALLERID(num)=8883335555)         

But I wasn't sure how to trigger it.

Dave

 

> -----Original Message-----
> From: [EMAIL PROTECTED] [mailto:[EMAIL PROTECTED] On 
> Behalf Of Ian Service
> Sent: Saturday, February 11, 2006 1:41 AM
> To: David Fishburn
> Cc: [email protected]
> Subject: [asterix] Re: [on-asterisk] Setting callerid (sixTel)
> 
> Hey Dave,
> 
> I gave it a go with my SixTel account,
> 
> Set(CALLERID(name)=S Head) ; ahem.
> Set(CALLERID(num)=4167777777) ; Toronto Star Classified
> 
> Then passed the call to my Bell line with callerID, it came 
> back with 14167777777 as the number and no name.  Stephan of 
> Unlimitel was saying that his gateway will do callerID name 
> late this year.
> 
> Hope that helps.
> 
> - Ian
> 
> 
> On 2/10/06, David Fishburn <[EMAIL PROTECTED]> wrote:
> 
> 
>       [EMAIL PROTECTED] 2.5
>       
>       I have a trunk going through iax.cc/sixTel.
>       
>       Dialing my cellphone always shows "Unknown number".  I 
> am trying to figure
>       out how to set the callerid.
>       Also inbound calls do not show the callerid properly either. 
>       
>       For the inbound, it looks like I should set the callerid under:
>       AMP->Setup->Inbound Routing->My Number
>       - I have the DID number set
>       - I left the Caller ID Number blank.
>       - If I put a value in here, like xxx-xxx-xxxx I can't 
> receive incoming 
>       calls.
>       
>       For outbound I updated the trunk as follows:
>       AMP->Setup->Trunks->iax.cc
>       - I set the Outbound Caller ID to  DS Fishburn <7digit#>
>       
>       I didn't find anything helpful at www-voip-info.org 
> <http://www-voip-info.org>  or google.
>       
>       Can anyone suggest where I might be going wrong?
>       
>       TIA,
>       Dave
>       
>       
>       
> ---------------------------------------------------------------------
>       To unsubscribe, e-mail: [EMAIL PROTECTED] 
> <mailto:[EMAIL PROTECTED]> 
>       For additional commands, e-mail: [EMAIL PROTECTED]
>       
>       
> 
> 
> 

Reply via email to