From what version of asterisk did yo upgrade, if you where running an
older copy chances are,you are now running a different echo cancellor,
and you will probably have to readjust your rx and tx gains.
Jitter however sounds network related, have you done a packet analysis
on your connection?
Phil.
Quoting Scott Ivory <[EMAIL PROTECTED]>:
Hi All,
After rebuilding my Asterisk box, I seem to be having some call quality
issues. Mostly intermittent jitter and some static. There are only two
users of this particular system. I didn't seem to have any problems before
the rebuild (aside from the hardware issues that prompted the rebuild). The
new box is an IBM NetVista with a 2.4 GHz processor, 384 MB of RAM running
Trixbox v1.1.
I ran top to see what the CPU/memory load is while on a call and it never
goes above 3 percent. Memory also looks good.
I'm on Rogers hi-speed, so bandwidth shouldn't be a problem. When I run
bandwidth tests I average about 2.5 megs down 600k up (far from the 6/800
I'm supposed to get)
Are there any utilities that I can use to help further diagnose the problem?
Thanks again!
Scott
