Hi all,
Thanks for all your answers. Eventually when talking to the Bell activation
tech, it was not what I was told. It was actually 2 full PRI each with their
23b+1d and they were just restricting on their side to 30 simultaneous calls.
An other case of "i was told by my telco that..."
Thanks again,
Dave Donovan wrote:
On Wed, Mar 19, 2008 at 12:57 PM, Andre Courchesne - Consultant
<[EMAIL PROTECTED]> wrote:
Hi,
Anyone knows hot to configure 1.5 PRI (23b+1d or first circuit and 12b on
second circuit) using a Sangoma A102d ? I am unsure of the wanpipeX, zaptel and
zapata configuration.
Thanks,
Andre, I don't know much about wanpipe but John's example below is a
good start to your config files. Note his caveat about the second PRI
being configured for stand-alone. Since yours is 12b, it seems that
it isn't. So, I'll add this:
What you need in your case is something called NFAS or Non Facility
Associated Signalling. That's just means that one D channel can
control B channels on more than one circuit. Good news, Asterisk
supports it.
http://www.voip-info.org/wiki/view/NFAS
Basically you define a the trunkgroup and spanmap that logically
associates physical circuits to logical groups. As I recall, it is
important to make sure that you name all your members in the right
order. You only have two circuits so it's more likely to be
all-or-nothing but in more complex cases, you have to define your
circuits in the same order as the carrier or else calls will mismatch.
IE D-channel will signal for call setup on member 10 and then setup
the call on member 33, or conversely the carrier will signal incoming
call on member 33 and your system will not see it and instead raise an
error on an unexpected call on member 10.
Good luck with your project,
Dave
--
----
Andre Courchesne - Consultant
Tel: (514) 667-8448
Cel: (514) 712-4064
web: http://www.net-forces.com
email: [EMAIL PROTECTED]
Skype: voipforces
MSN: [EMAIL PROTECTED]
---------------------------------------------------------------------
To unsubscribe, e-mail: [EMAIL PROTECTED]
For additional commands, e-mail: [EMAIL PROTECTED]
---------------------------------------------------------------------
To unsubscribe, e-mail: [EMAIL PROTECTED]
For additional commands, e-mail: [EMAIL PROTECTED]
--
----
Andre Courchesne - Consultant
Tel: (514) 667-8448
Cel: (514) 712-4064
web: http://www.net-forces.com
email: [EMAIL PROTECTED]
Skype: voipforces
MSN: [EMAIL PROTECTED]
---------------------------------------------------------------------
To unsubscribe, e-mail: [EMAIL PROTECTED]
For additional commands, e-mail: [EMAIL PROTECTED]
