Thank you Dave. On Fri, Mar 27, 2009 at 4:54 PM, Dave Donovan <[email protected]>wrote:
> Lloyd, > > Further to Chuck's post, here's a link to the pfSense wiki page on > inbound load balancing. I don't have any experience with it > personally but it wouldn't take more than an hour and an old machine > to have working setup that you could play around with. > > http://doc.pfsense.org/index.php/Inbound_Load_Balancing > > Dave > > On Fri, Mar 27, 2009 at 4:48 PM, Chuck Mariotti <[email protected]> > wrote: > > I have setup a pfSense box with three NICs... LAN, WAN, WAN2... > > > > pfSense can monitor each WAN and loadbalance across them. If one fails, > it can use the other... when the failed comes out of failed state, it can > load balance them again. I have this setup with a T1 (Static) and Rogers > Internet Unplugged (DHCP)... I have only had it working for a week, so I > don't have any reports on issues... > > > > As Doug said, if it's strictly outbound that is needed to be failover, > this is fairly easy. However, if you need inbound I think it's fairly tough > to remap external IPs to different ISPs. > > > > Regards, > > Chuck > > > > -----Original Message----- > > From: Aloysius Thevarajah Lloyd [mailto:[email protected]] > > Sent: Friday, March 27, 2009 4:03 PM > > To: [email protected] > > Subject: [on-asterisk] Dual Wan and Load Balancing > > > > Hi Everyone, > > > > How to build a reliable Dual Wan & load balancing in the Following > Scenarios > > > > *Scenario-1* > > > > ISP1 - DSL with Static IP > > ISP2 - Broadband DHCP > > > > *Scneraio-2* > > > > ISP1 - DSL with Static IP > > ISP2 - DSL with Static IP > > > > *Scenario-3* > > > > ISP1 - Broadband DHCP > > ISP2 - Broadband DHCP > > > > > > Does any one have any recommendation Hardware ( Not Expensive) or > Software( > > I prefer) ? > > > > > > > > Thank you > > Lloyd > > > > --------------------------------------------------------------------- > > To unsubscribe, e-mail: [email protected] > > For additional commands, e-mail: [email protected] > > > > > > --------------------------------------------------------------------- > To unsubscribe, e-mail: [email protected] > For additional commands, e-mail: [email protected] > >
