The "Answer After" rings needs to be set to at least two for callerid to
be detected. In 1.1.2.2 it doesn't support a value of less than two.
There's no fax detection in this unit.
The SPA-400 is a 4 port FXO gateway meant to be used with the SPA-9000,
and is both fairly stupid and not as flexible in terms of settings as the
SPA-3201/2201/etc series.
As often seems to be the case when I run in to bad behavior, upgrading
the firmware from 1.0.0.2 to 1.1.2.2 got rid of the premature off-hook
and 'beep'. However, now it postpends the port ID to the callerid-name of
any inbound calls *eyeroll*, so instead of 'Simon Ditner', I get 'Simon
Ditner - port1'. At least I can trim that off in the dialplan.
re,
spd
On Tue, 14 Apr 2009, Elliott Jeyaseelan wrote:
Simon,
I am assuming you have disabled "Answer after x rings" or set it to
minimum (1 or 0?) and secondly Fax detect can be disabled if you don't
need that feature.
Elliott
-----Original Message-----
From: Simon P. Ditner [mailto:[email protected]]
Sent: Tuesday, April 14, 2009 12:26 PM
To: [email protected]
Subject: [on-asterisk] linksys spa400 annoyances
I've found documentation around the spa400 rather scarce,
especially regarding some annoying behaviors:
First, it picks up the analog line before ringing through to
my SIP phones, and second, it beeps when it initially picks
up the line.
Anyone know how to get around this so that it doesn't answer
before the called party answers, and doesn't "beep" upon answering?
Cheers,
spd
---------------------------------------------------------------------
To unsubscribe, e-mail: [email protected]
For additional commands, e-mail: [email protected]
