also for the iax part your getting a fail on that..
do you see an iax proile identified by 200 or fully implement properly
(ie do you have a peer type defined?) a simple iax2 show peers should
tell your this.
Phil
Philip Mullis wrote:
gosh my typo's where bad there... take out the work macro- when you
call it in the dialplan.. M and Macro will look for the macro-
preceding your word.. ie if you have made something called
macro-smdr.. its called via Macro(smdr,arg1,arg2) etc.. or
M(smdr,arg1,arg2) etc...
Phil
Philip Mullis wrote:
Andre take out the work macro, if you have something call macro-smdr,
you just call it via M(smdr)
Andre Courchesne - Consultant wrote:
Ok, I have the following macro:
[macro-smdr]
exten => s,1,NoOp(In Macro smdr)
And the following dialplan:
exten => 1111,1,Dial(IAX2/200,,M(smdr))
Whan I dial 1111, I see the following result:
[Jun 25 12:55:04] VERBOSE[2601] logger.c: -- Executing
[1...@from-internal:1] Dial("IAX2/100-4558",
"IAX2/200||M(macro-smdr)") in new stack
[Jun 25 12:55:04] WARNING[2601] app_dial.c: Unable to create channel
of type 'IAX2' (cause 20 - Unknown)
[Jun 25 12:55:04] VERBOSE[2601] logger.c: == Everyone is
busy/congested at this time (1:0/0/1)
Any ideas? After lunch I'll setup with sip hard phones to see if it
makes a difference.
---------------------------------------------------------------------
To unsubscribe, e-mail: [email protected]
For additional commands, e-mail: [email protected]
---------------------------------------------------------------------
To unsubscribe, e-mail: [email protected]
For additional commands, e-mail: [email protected]
---------------------------------------------------------------------
To unsubscribe, e-mail: [email protected]
For additional commands, e-mail: [email protected]
