Hi Mark, I thought I'd give your thread a bump. Did you get a response on this, it looks like a good question.
I wonder if Lloyd or any of our other Cisco wizards are tuned in and might be able to shed some light on the subject. Dave On Sat, Jul 31, 2010 at 6:19 PM, Mark Brown <[email protected]> wrote: > Hi Taugers! > > I'm a bit of a cisco newb, and I was wondering if someone here could smack > me around with a cisco clue stick :-) > > I'm in the midst of trying to prioritize my IAX2 connections, and have the > rest of my connections do fair-queue. > > I found the following on http://www.voip-info.org/wiki/view/QoS+Cisco > (below). This is for the use-case with a ADSL WIC installed. (hence the ATM > interface in the example) > > I am connecting a ADSL modem to a Cisco 2611, and running a PPPoE client on > the route which is similar, however I'm not sure where to apply the outbound > service-policy. > > I figure it doesn't make sense to connect it to int eth 0/1, which is PPPoE > to the modem. I don't think it makes sense to apply it to the Dialer1 > interface. > > Virtual-Access, Virtual-Template - can someone clear some confusion for me > please - thanks! > > I'm using IOS 12.3(26). > > /Mark > ------- > > class-map match-any signaling > > match access-group 102 > class-map match-any voice > match access-group 101 > > policy-map VoicePolicy > class voice > priority 384 > class signaling > priority 128 > class class-default > fair-queue > > interface ATM0/0/0 > no ip address > no atm ilmi-keepalive > bundle-enable > dsl operating-mode auto > pvc 0/35 > vbr-nrt 768 768 > tx-ring-limit 3 > service-policy output VoicePolicy > pppoe-client dial-pool-number 1 > > interface Dialer0 > ip unnumbered FastEthernet0/0 > no ip redirects > no ip unreachables > ip mtu 1492 > encapsulation ppp > no ip route-cache cef > no ip route-cache > ip tcp adjust-mss 1452 > no ip mroute-cache > dialer pool 1 > no cdp enable > ppp authentication pap chap callin > ppp pap sent-username <your PPPoE Username> password 0 <Your > PPPoE Password> > > access-list 101 remark ***QoS for RTP and IAX*** > access-list 101 permit udp any any dscp ef > access-list 102 remark ***QOS for SIP*** > access-list 102 permit udp any any dscp af41 > > > --------------------------------------------------------------------- To unsubscribe, e-mail: [email protected] For additional commands, e-mail: [email protected]
