On May 4, 2006, at 9:40 PM, Kristian Kielhofner wrote: > Kristian Kielhofner wrote: > > 3) Layer 2 bridging is now fully supported. You can bridge madwifi > access points/clients, ethernet interfaces, ethernet interfaces with > vlans, anything you want! >
Question, if I have a net4801 in pbx-only mode (only eth0 used), can the new "BRIDGE" feature allow me to tie eth0, eth1 and eth2 together as a mini-switch at a layer 2 level? How would that be done? Thanks Lonnie per 0.4.2 rc.conf: ##BRIDGES ##If configured with bridge-utils AstLinux can setup layer 2 bridges for you ##Very useful for access points, small "switches" etc. You can define up to ##three total (BRIDGE0, BRIDGE1, BRIDGE2). This example creates device "br0" ##and adds the interfaces (seperated by spaces) to the bridge. Bridges can ##include vlans as defined above. #BRIDGE0="eth1 ap0" #BRIDGE1="ap1 eth0" #BRIDGE2="ath0 eth1" _______________________________________________ Astlinux-users mailing list [email protected] http://lists.kriscompanies.com/mailman/listinfo/astlinux-users Donations to support AstLinux are graciously accepted via PayPal to [EMAIL PROTECTED]
