I got the following output while trying to boot Astlinux on a Soekris 4801 from
a Trascend compact flash card:
Booting 'AstLinux (Boot from CF - Use USB KeyDisk)'
root (hd0,0)
Filesystem type is ext2fs, partition type 0x83
kernel /boot/bzImage root=/dev/hda1 console=ttyS0,19200n8 astlinux=net4801 astk
d=/dev/sda1 ide=nodma
[Linux-bzImage, setup=0x1400, size=0x11287e]
savedefault
Linux version 2.6.16.12 ([EMAIL PROTECTED]) (gcc version 3.4.2) #1 PREEMPT Tue
Sep 11 00:57:02 EDT 2007
BIOS-provided physical RAM map:
BIOS-e820: 0000000000000000 - 000000000009fc00 (usable)
BIOS-e820: 000000000009fc00 - 00000000000a0000 (reserved)
BIOS-e820: 00000000000f0000 - 0000000000100000 (reserved)
BIOS-e820: 0000000000100000 - 0000000008000000 (usable)
BIOS-e820: 00000000fff00000 - 0000000100000000 (reserved)
128MB LOWMEM available.
DMI not present or invalid.
Allocating PCI resources starting at 10000000 (gap: 08000000:f7f00000)
Built 1 zonelists
Kernel command line: root=/dev/hda1 console=ttyS0,19200n8 astlinux=net4801
astkd=/dev/sda1 ide=nodma
ide_setup: ide=nodma : Prevented DMA
Initializing CPU#0
PID hash table entries: 1024 (order: 10, 16384 bytes)
scx200hr: timer not yet accessible; will probe later.
Detected 266.663 MHz processor.
Using tsc for high-res timesource
Console: colour dummy device 80x25
Dentry cache hash table entries: 32768 (order: 5, 131072 bytes)
Inode-cache hash table entries: 16384 (order: 4, 65536 bytes)
Memory: 127028k/131072k available (1418k kernel code, 3624k reserved, 557k
data, 116k init, 0k highmem)
Checking if this processor honours the WP bit even in supervisor mode... Ok.
Calibrating delay using timer specific routine.. 534.33 BogoMIPS (lpj=267167)
Mount-cache hash table entries: 512
CPU: NSC Unknown stepping 01
Checking 'hlt' instruction... OK.
NET: Registered protocol family 16
PCI: PCI BIOS revision 2.01 entry at 0xf7861, last bus=0
PCI: Using configuration type 1
Linux Plug and Play Support v0.97 (c) Adam Belay
PnPBIOS: Scanning system for PnP BIOS support...
PnPBIOS: PnP BIOS support was not detected.
SCSI subsystem initialized
usbcore: registered new driver usbfs
usbcore: registered new driver hub
PCI: Probing PCI hardware
TC classifier action (bugs to [EMAIL PROTECTED] cc [EMAIL PROTECTED])
scx200: NatSemi SCx200 Driver
scx200: GPIO base 0x6100
scx200: Configuration Block base 0x6000
switching to scx200 high-resolution timer (255961 cpt)
Initializing Cryptographic API
io scheduler noop registered
io scheduler cfq registered (default)
isapnp: Scanning for PnP cards...
isapnp: No Plug & Play device found
Real Time Clock Driver v1.12ac
PNP: No PS/2 controller found. Probing ports directly.
i8042.c: Can't read CTR while initializing i8042.
Serial: 8250/16550 driver $Revision: 1.90 $ 4 ports, IRQ sharing enabled
serial8250: ttyS0 at I/O 0x3f8 (irq = 4) is a 16550A
serial8250: ttyS1 at I/O 0x2f8 (irq = 3) is a 16550A
RAMDISK driver initialized: 16 RAM disks of 4096K size 1024 blocksize
loop: loaded (max 8 devices)
Uniform Multi-Platform E-IDE driver Revision: 7.00alpha2
ide: Assuming 33MHz system bus speed for PIO modes; override with idebus=xx
SC1200: IDE controller at PCI slot 0000:00:12.2
SC1200: chipset revision 1
SC1200: not 100% native mode: will probe irqs later
ide0: BM-DMA at 0xe000-0xe007, BIOS settings: hda:pio, hdb:pio
ide1: BM-DMA at 0xe008-0xe00f, BIOS settings: hdc:pio, hdd:pio
hdb: TRANSCEND, ATA DISK drive
SC1200: set xfer mode failure
ide0 at 0x1f0-0x1f7,0x3f6 on irq 14
hdb: max request size: 128KiB
hdb: 1993824 sectors (1020 MB) w/1KiB Cache, CHS=1978/16/63
hdb: hdb1
ohci_hcd 0000:00:13..0: OHCI Host Controller
ohci_hcd 0000:00:13.0: new USB bus registered, assigned bus number 1
ohci_hcd 0000:00:13.0: irq 11, io mem 0xa0003000
usb usb1: configuration #1 chosen from 1 choice
hub 1-0:1.0: USB hub found
hub 1-0:1.0: 3 ports detected
Initializing USB Mass Storage driver...
usbcore: registered new driver usb-storage
USB Mass Storage support registered.
mice: PS/2 mouse device common for all mice
NET: Registered protocol family 2
IP route cache hash table entries: 2048 (order: 1, 8192 bytes)
TCP established hash table entries: 8192 (order: 3, 32768 bytes)
TCP bind hash table entries: 8192 (order: 3, 32768 bytes)
TCP: Hash tables configured (established 8192 bind 8192)
TCP reno registered
TCP bic registered
NET: Registered protocol family 1
NET: Registered protocol family 17
Using IPI Shortcut mode
VFS: Cannot open root device "hda1" or unknown-block(0,0)
Please append a correct "root=" boot option
Kernel panic - not syncing: VFS: Unable to mount root fs on unknown-block(0,0)
Any idea??
I downloaded the latest image from sourceforget.net, also I tried to build it
using ADE but something is wrong.
James Haayen
__________________________________________________
Do You Yahoo!?
Tired of spam? Yahoo! Mail has the best spam protection around
http://mail.yahoo.com -------------------------------------------------------------------------
This SF.net email is sponsored by: Splunk Inc.
Still grepping through log files to find problems? Stop.
Now Search log events and configuration files using AJAX and a browser.
Download your FREE copy of Splunk now >> http://get.splunk.com/
_______________________________________________
Astlinux-users mailing list
[email protected]
https://lists.sourceforge.net/lists/listinfo/astlinux-users
Donations to support AstLinux are graciously accepted via PayPal to [EMAIL
PROTECTED]
