Something like this should be sufficient:
--snip--
#!/bin/sh
echo "se st $2 mw on" >> /dev/ttyS1
--snip--
$2 means the second variable[1] which from the docs is the extension #
passed to the script when externnotify[2] is used.
[1] http://web.mit.edu/answers/unix/unix_parameters.html
[2] http://www.voip-info.org/wiki-Asterisk+config+voicemail.conf
On Fri, Feb 22, 2008 at 6:17 AM, Michael Keuter <[EMAIL PROTECTED]> wrote:
[...]
> You have to connect to a special configured serial port on the
> Meridian and then send the correct commands. E.g. "se st 100 mw on"
> sets the voicemail lamp on ext. 100 on (you don't even need an answer
> from the Meridian).
>
> I know I must call a script from externnotify from the voicemail.conf.
> I am not a Linux expert, so what commands can I use to send the
> serial strings over the 2nd serial port of the net4801?
>
>
--
Grover Beach, California, USA
http://blog.joshrichards.org [EMAIL PROTECTED] +1 (805)
471-6923
http://www.linkedin.com/in/joshrichards
Supporting these causes: Water.org, Kiva.org & RoomToRead.org
-------------------------------------------------------------------------
This SF.net email is sponsored by: Microsoft
Defy all challenges. Microsoft(R) Visual Studio 2008.
http://clk.atdmt.com/MRT/go/vse0120000070mrt/direct/01/
_______________________________________________
Astlinux-users mailing list
Astlinux-users@lists.sourceforge.net
https://lists.sourceforge.net/lists/listinfo/astlinux-users
Donations to support AstLinux are graciously accepted via PayPal to [EMAIL
PROTECTED]
