Thank you, i will check it tomorrow. Regards,
Jonathan GF Philip Prindeville wrote: > Have you tried creating a bridge interface with all 4 ethernet > interfaces in it? In /etc/rc.conf, put: > > BRIDGE0="eth0 eth1 eth2 eth3" > > and then have: > > INTIF="br0" > > -Philip > > Jonathan GF wrote: >> Hi, >> >> i use a Net5501 board in PBX-only mode. I would like to use the other >> interfaces to connect phones in my demo system. >> >> Is it posible in any way? >> >> Thanks in advance. >> Regards, >> >> Jonathan GF > > > ------------------------------------------------------------------------- > Sponsored by: SourceForge.net Community Choice Awards: VOTE NOW! > Studies have shown that voting for your favorite open source project, > along with a healthy diet, reduces your potential for chronic lameness > and boredom. Vote Now at http://www.sourceforge.net/community/cca08 > _______________________________________________ > Astlinux-users mailing list > [email protected] > https://lists.sourceforge.net/lists/listinfo/astlinux-users > > Donations to support AstLinux are graciously accepted via PayPal to [EMAIL > PROTECTED] ------------------------------------------------------------------------- Sponsored by: SourceForge.net Community Choice Awards: VOTE NOW! Studies have shown that voting for your favorite open source project, along with a healthy diet, reduces your potential for chronic lameness and boredom. Vote Now at http://www.sourceforge.net/community/cca08 _______________________________________________ Astlinux-users mailing list [email protected] https://lists.sourceforge.net/lists/listinfo/astlinux-users Donations to support AstLinux are graciously accepted via PayPal to [EMAIL PROTECTED]
