Tom, Go here:
http://wiki.soekris.info/5501_Interfaces Grab some connectors and you can easily power one FSX directly off the net5501 board. You only need the 12V as John pointed out. Darrick Tom Chadwin wrote: > Hello all > > I've been working purely with FXO modules until now. I've now > installed 1 FXS onto the TDM410P in my net5501, alongside the three > FXO modules already there. Because I was previously only using FXOs, > the TDM has not been connected to the power on the 5501 mainboard. I > have no room to plug the normal molex connector into the TDM, so I'm > going to have to do it myself. > > My question is, given the voltage requirements of a single FXS, which > pins from the mainboard socket should be connected up? It seems to > supply both 12V and 5V. I've seen photos of someone else's set-up with > 3 FXSs (thanks, Martin!), and this seems to connect the 12V and ground > pin from the mainboard to the two pins on the TDM card molex at the > TDM port 4 side. Should I connect up 12V, 5V, or both? > > Thanks > > Tom ------------------------------------------------------------------------------ Apps built with the Adobe(R) Flex(R) framework and Flex Builder(TM) are powering Web 2.0 with engaging, cross-platform capabilities. Quickly and easily build your RIAs with Flex Builder, the Eclipse(TM)based development software that enables intelligent coding and step-through debugging. Download the free 60 day trial. http://p.sf.net/sfu/www-adobe-com _______________________________________________ Astlinux-users mailing list Astlinux-users@lists.sourceforge.net https://lists.sourceforge.net/lists/listinfo/astlinux-users Donations to support AstLinux are graciously accepted via PayPal to pay...@krisk.org.
