On 07/06/2010 01:55 PM, Shamus Rask wrote: > My apologies to the board, but I have searched the forums and read the > documentation. I've just downloaded AstLinux 0.72 and am anxious to get > it working, however have run into a couple of problems. > > First, I'm using a Jetway mini-ITX board (J7F4K1G2E); this is based on > the VIA CN700. I'm using the VIA C7 image and have managed to get > AstLinux to boot. However, it does not look like either of the GigE > ports are recognized. > > After booting the board, I plugged in my USB key and issued the genkd > command, then rebooted. I looked at /etc/rc.conf, but it says that it is > auto-generated and should not be edited. Instead, I remounted / and > tried commenting out/un-commenting the Realtek 8169 drivers in > /etc/rc.modules. On reboot, /etc/rc.modules had reverted to its original. > > I think I am missing some basics with AstLinux. Any thoughts on how to > load the drivers? >
Please read the fine documentation at doc.astlinux.org. Specifically, see End-user documentation and New Installation. If you follow those steps to create a unionfs partition, you'll have the proper persistent storage and will be able to change files. -- Darrick Hartman DJH Solutions, LLC http://www.djhsolutions.com ------------------------------------------------------------------------------ This SF.net email is sponsored by Sprint What will you do first with EVO, the first 4G phone? Visit sprint.com/first -- http://p.sf.net/sfu/sprint-com-first _______________________________________________ Astlinux-users mailing list [email protected] https://lists.sourceforge.net/lists/listinfo/astlinux-users Donations to support AstLinux are graciously accepted via PayPal to [email protected].
