>So probably the air condition you have forces the rate control to pick >MCS7 as the most suitable rates.
>>>In open AP mode (bridge), CUS223 HW (not WLE900VX however) and on >>>AP135 platform (customized openwrt SW + bleeding edge of >>>ath10k/wireless subsystem souces - private backports tarball).. for >>>UDP (last time I measured) I have around 820Mpbs for UCP both ways and >>>720Mbps TCP. >> >> This is in NSS3 -MCS9? Did you get better or worse rate if you clear the mask >> (iw wlanX set bitrates) cause if I don't config rate, from AP to STA I have >> the best rate >> (ie same as MCS7) but from STA to AP my rate is much lower than MCS7 (240 >> Mbps >> vs 370 Mbps in TCP). >Yes, NSS-3; Over the RF-cables I'm easily able to get MCS9 rates >transmitions without any forced settings (the rate control is picking >the highest rates). Hi Bartosz, I connect 2 antennas on my 2 devices together by a RF-cables with an attenuator around -60dBm, config each device to use one antenna and force rate to NSS1. But the TCP through put of MCS7 (230 Mbps) is always slightly higher than MCS8 (210Mbps) and 9 (190Mbps). Can you give me some detail about your RF-cables test-bed? (for example which attenuator did you use?,etc...) Thank you in advance. NGUYEN Vu Hai Acita-Sodielec Route de Mayres - B.P. 9 12100 St GEORGES DE LUZENCON FRANCE _______________________________________________ ath10k mailing list [email protected] http://lists.infradead.org/mailman/listinfo/ath10k
