Hi all, I haven't seen this brought up before, but has anyone done power meter readings on ath10k with the various firmware? If anyone has, can you verify my findings below? There seems to be an issue between the two firmware. Please note that I've tested both the latest ath10k git/master as well as a version a few months back.
I just compared 10.1.467.2-1 and 999.999.0.636 firmware versions on several WLE900VX cards (to verify consistency). Reading the datasheet (http://www.compex.com.sg:809/Datasheets/WLE900VX_Dsv1.0.3-271013-I.pdf) shows that at the highest MCS rate it supports at the 5GHz range, the max txpower per chain is 10dBm, and aggregate txpower is 15dBm (+/- 2dB). My test setup was as follows (please excuse my ascii art): ---------- |dut(ap) | | | |C C C | |H H H | |0 1 2 | ---------- | | |_______[power-meter] | | ---------- |0 1 2 | |H H H | |C C C | | | |dut(sta) | ---------- If the above art is unreadable, that's two WLE900VX radios, one configured as an AP, the other as a STA. CH0 and CH1 were connected via 30dBm attenuators and the third chain of the radio configured as an AP was connected to the power meter via a 10dB attenuator. With cabling etc, there was probably about a 15dB attenuation between the power meter and radio. I used software (iw) to configure the txpower of the ap radio and performed an iperf test to generate traffic (if anyone knows how to get a single radio into continuous transmit mode, please let me know, it will help this test immensely). The follow are my results: | Firmware | txpower (software) | reading | +15dBm offset | | 10.1.467.2-1 | 15 | -6 | 9 | | '' | 10 | -10.6 | 4.4 | Then same radio(s), different firmware: | Firmware | txpower (software) | reading | +15dBm offset | | 999.999.0.636 | 15 | 10.3 | 25.3 | | '' | 10 | 7.5 | 22.5 | As you can see, the results are wildly different. Is this something that the driver can fix? Or is this a firmware problem? It goes without saying that this is a big danger for devices etc connected to the radio. - Pushpal _______________________________________________ ath10k mailing list [email protected] http://lists.infradead.org/mailman/listinfo/ath10k
