Rajkumar Manoharan <[email protected]> writes: > On Tue, Nov 04, 2014 at 01:34:37AM +0200, Kalle Valo wrote: >> Rajkumar Manoharan <[email protected]> writes: >> >> > For packet log, the transmitted frame 802.11 header alone is sufficient. >> > Recording entire packet is also consuming lot of disk space. To optimize >> > this, tx and rx data tracepoints are splitted into header and payload >> > tracepoints. >> > >> > -DECLARE_EVENT_CLASS(ath10k_data_event, >> > +#define ATH10K_FRM_HDR_LEN \ >> > + ieee80211_hdrlen(((struct ieee80211_hdr *)data)->frame_control) >> >> This macro does not look good. I would recommend to follow what Johannes >> suggested: >> >> "It would be worth hiding that inside the tracepoint's assign function, >> so instead of passing data/len here you'd pass the full skb, or the full >> skb data/skb len, like this: >> >> ar, skb->data, skb->len >> >> to both tracers. Then inside the tracer you can do the hdrlen check, and >> that way move the code into the tracing so it's not hit when tracing is >> disabled." > > v2 does the same. tracing functions just take ar, skb->data and skb->len. > header check is handled inside tracing funtions. > > I do not understand your concerns. :(
Sorry, I was confusing. I meant that wouldn't it be better to pass the skb pointer instead of skb-data and skb->len? I understood that was what Johannes suggested. But ATH10K_FRM_HDR_LEN is the problem. To simplify this, what if you just always send the first 30 bytes (or whatever would be the max header length)? Also should you check that skb->len is at least the length defined by ieee80211_hdrlen()? -- Kalle Valo _______________________________________________ ath10k mailing list [email protected] http://lists.infradead.org/mailman/listinfo/ath10k
