On 27 April 2015 at 15:00, Bob Copeland <m...@bobcopeland.com> wrote: > On Sun, Apr 26, 2015 at 10:15:52AM -0400, Bob Copeland wrote: >> So, progress! >> >> There's still an issue with datapath -- while it looks like we can establish >> plinks, I couldn't get unicast traffic flowing even if manually setting up >> mpaths and arp table entries. I haven't yet got all of my 5 ghz capable gear >> in the same room to monitor and see where the problem lies. > > Now I had a chance to monitor it, and in so doing, rediscovered this patch of > Chun-Yeow's: > > http://lists.infradead.org/pipermail/ath10k/2014-September/003206.html > > In fact my broadcasts were truncated and the above change makes the broadcast > ARPs look correct over the air. The (non-ath10k) target mesh STA replies with > broadcast PREQ but that is not received / processed / replied-to by the > ath10k device. > > Perhaps there is a BSSID filter enabled or something like that (in mesh > there's no BSSID, just individual addresses on group addressed frames).
In that case try creating a monitor interface and bring it up. This should prompt ath10k to create monitor vdev and subsequently disable most Rx filters in firmware. MichaĆ _______________________________________________ ath10k mailing list ath10k@lists.infradead.org http://lists.infradead.org/mailman/listinfo/ath10k